128517

Active

RFID read/write device UHF for connecting external antennas, USA and Canada

All alternatives

Technical parameters

Power
Input current	20 mA
Input voltage	24 V DC
Operating voltage	U B \| 24 V DC ± 20 %
Output current	Optocoupler: 20 mA Relay: 1 A switching current, 2 A continuous load
Output voltage	24 V DC
Power consumption	P 0 \| 24 VA
Power Output	100 mW … 1 W adjustable in 100 mW increments
AC and DC characteristics
Operating frequency	902 … 928 MHz: USA, Canada Transmission licenses for other countries on request
Environment and package
Ambient temperature	-40 ... 70 °C (-40 ... 158 °F)
Height	157 mm
Height 157 mm Width 260 mm Length 68 mm	Height \| 157 mm \| Width \| 260 mm \| Length \| 68 mm
Storage temperature	-25 ... 85 °C (-13 ... 185 °F)
Other
Climatic conditions	Air humidity 5 ... 95 % , non-condensing
Connection	M8 connector, 8-pin
Degree of protection	IEC 60529
FCC approval	This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Housing	powder coated aluminum
Housing powder coated aluminum	Housing \| powder coated aluminum
IC approval	This device complies with Industry Canada licence-exempt RSS standard(s) and with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Input type	Optocoupler
Interface type	RS-232, Ethernet, USB (On-The-Go), Wiegand (Scan Mode Interface)
LED indication	16 LEDs for displaying the operating and antenna status
Length	68 mm
Mass	approx. 1800 g
Number of inputs	2
Number of outputs	4
Output type	2 x optocouplers, 2 x relays
Radio approval	USA: FCC IREIURF800 Canada: IC 7037A-IURF800
RFID	ISO/IEC 18000-63
Shock and impact resistance	Vibration (sine): 1 g, 10–150 Hz according to EN 60068-2-6 Shock (half-sine): 30 g according to EN 60068-2-27
Width	260 mm

Documents

No documents are linked to this part yet.