Figure 4-2. DQN Package, 4-Pin…
Texas InstrumentsUnited States
IC REG LINEAR 3.2V 250MA 4X2SON
LP5907SNX-3.2/NOPB is a 3.2V fixed-output, 250mA low-noise LDO regulator in X2SON (DQN) package, with 2.2V-5.5V input range, thermal shutdown, and short-circuit protection.Checked against the datasheet
All alternatives
View full reportTechnical parameters
Key specs
Output voltage3.2 V
Output current250 mAMax
Input voltage2.2 ~ 5.5 V
Dropout voltage250 mVTyp · Typ 250mV (IOUT=250mA
Quiescent current12 µATyp · Typ 12μA (VEN=1.2V,IOUT=0mA)
Datasheet-verified parameters
23 items| Parameter | Value and test conditions | Source |
|---|---|---|
| Output voltage | 3.2V (Fixed) | |
| Output current | Max 250mA | |
| Input voltage range | 2.2V to 5.5V | |
| Dropout voltage | Typ 250mV (IOUT=250mA, SOT-23, X2SON packages) | |
| Quiescent current | Typ 12μA (VEN=1.2V, IOUT=0mA); Max 25μA | |
| Package | X2SON (DQN), 4 Pins, 1mm × 1mm |
All parameters (22)
| Power | |
|---|---|
| Current - Output | 250mA |
| Current - Quiescent (Iq) | 25 µA |
| Current - Supply (Max) | 425 µA |
| Voltage Dropout (Max) | 0.25V @ 250mA |
| Voltage - Input (Max) | 5.5V |
| Voltage - Output (Max) | - |
| Voltage - Output (Min/Fixed) | 3.2V |
| AC and DC characteristics | |
| PSRR | 90dB ~ 60dB (100Hz ~ 100kHz) |
| Environment and package | |
| Mounting Type | Surface Mount |
| Operating Temperature | -40°C~125°C |
| Package | Tape & Reel (TR); Cut Tape (CT); Digi-Reel® |
| Package / Case | 4-XDFN Exposed Pad |
| Supplier Device Package | 4-X2SON (1x1) |
| Other | |
| Base Product Number | LP5907 |
| Control Features | Enable |
| Mfr | Texas Instruments |
| Number of Regulators | 1 |
| Output Configuration | Positive |
| Output Type | Fixed |
| Product Status | Active |
| Protection Features | Over Temperature, Short Circuit |
| Series | - |
Pinout and package
Figure 4-2. DQN Package, 4-Pin…
| Pin | Name | Function | Source |
|---|---|---|---|
| 1 | OUT: Regulated output voltage. Connect a minimum 1μF low-ESR capacitor to this pin. Connect this output to the load circuit. An internal 230Ω (typical) pulldown resistor prevents a charge remaining on VOUT when the regulator is in shutdown mode (VEN low). | ||
| 2 | GND: Common ground. | ||
| 3 | EN: Enable input. A low voltage (<VIL) on this pin turns the regulator off and discharges the output pin to GND through an internal 230Ω pulldown resistor. A high voltage (>VIH) on this pin enables the regulator output. This pin has an internal 1MΩ pulldown resistor to hold the regulator off by defa | ||
| 4 | IN: Input voltage supply. Connect a 1μF capacitor at this input. | ||
| 5 | Thermal Pad: Thermal pad for the X2SON package, connect to GND or leave floating. Do not connect to any potential other than GND. |
Documents
Datasheet-verified content is extracted by AI from the manufacturer datasheet. Click a page number to view the original.