Все аналоги
Полный отчётТехнические параметры
| Питание | |
|---|---|
| High operating voltage minus voltage drop Low ≤ 2.8 V | High | operating voltage minus voltage drop | Low | ≤ 2.8 V |
| Input current | < 6 mA |
| Load current | 20 mA |
| No-load supply current | I 0 | max. 140 mA |
| Operating voltage | U B | 10 ... 30 V DC |
| Power consumption | P 0 | ≤ 2.5 W , without output drivers |
| Voltage drop | ≤ 2.5 V |
| Характеристики по постоянному и переменному току | |
| Code change frequency | 400 kHz |
| De-energized delay | 300 ns |
| Noise immunity | EN 61000-6-2:2005 |
| Rise time | 300 ns |
| Switch-off delay | ≥ 1 ms |
| Switch-on delay | ≥ 1 ms |
| Условия эксплуатации и корпус | |
| Operating temperature | -40 ... 85 °C (-40 ... 185 °F) cable models: -30 ... 70 °C (fixed installation) -5 ... 70 °C (movable installation) |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) (cable models: -5 ... 70 °C) |
| Другое | |
| Cable | ∅9 mm, 15 x 2 x 0.14 mm 2 , 2 m |
| Climatic testing | DIN EN 60068-2-3, no moisture condensation |
| Code course (counting direction) | cw ascending (clockwise rotation, code course ascending) |
| Code preparation time | 0.3 ms |
| Combination 1 | housing: powder coated aluminum flange: aluminum shaft: stainless steel |
| Combination 2 (Inox) | housing: stainless steel flange: stainless steel shaft: stainless steel |
| Connector | type 9426, 26-pin |
| Degree of protection | DIN EN 60529, IP65 |
| Emitted interference | EN 61000-6-4:2007 |
| High | operating voltage minus voltage drop |
| High 10 ... 30 V Low 0 ... 2 V | High | 10 ... 30 V | Low | 0 ... 2 V |
| Input type | Selection of counting direction (cw/ccw) |
| Interface type | Push-pull, parallel , short-circuit protected |
| Linearity | ± 0.5 LSB |
| Low | ≤ 2.8 V |
| Mass | approx. 400 g (combination 1) approx. 800 g (combination 2) |
| Moment of inertia | 30 gcm 2 |
| Multiturn | 25 Bit |
| Multiturn 25 Bit | Multiturn | 25 Bit |
| Output code | Gray code, binary code |
| Rotational speed | max. 12000 min -1 |
| Shock resistance | DIN EN 60068-2-27, 100 g , 6 ms |
| Signal duration | min. 10 ms |
| Starting torque | ≤ 5 Ncm |
| UL approval | cULus Listed, General Purpose, Class 2 Power Source |
| Vibration resistance | DIN EN 60068-2-6, 10 g , 10 ... 2000 Hz |
Изображения
Документы
К этому компоненту пока не привязаны документы.