Все аналоги
Полный отчётТехнические параметры
| Питание | |
|---|---|
| No-load supply current | I 0 | ≤ 40 mA |
| Operating voltage | U B | 10 ... 30 V DC , ripple 10 % SS |
| Output current | current source < 2.5 mA |
| Power consumption | P 0 | ≤ 400 mW |
| Rated operating current | I e | 100 mA , short-circuit/overload protected |
| Voltage drop | U d | ≤ 2.5 V |
| Характеристики по постоянному и переменному току | |
| 0 Level 0 ... 1 V 1 Level 2.5 V ... U B Input impedance > 22 kΩ Output current current source < 2.5 mA Pulse length ≥ 1 ms with external control, low active | 0 Level | 0 ... 1 V | 1 Level | 2.5 V ... U B | Input impedance | > 22 kΩ | Output current | current source < 2.5 mA | Pulse length | ≥ 1 ms with external control, low active |
| Input impedance | > 22 kΩ |
| Repeat accuracy | ≤ ± 0.1 % of full-scale value |
| Response delay | minimum : 13 ms factory setting: 49 ms |
| Switching frequency | f | factory setting: 12 Hz programmable max. 27 Hz |
| Time delay before availability | t v | ≤ 300 ms |
| Transducer frequency | approx. 255 kHz |
| Условия эксплуатации и корпус | |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) When fixing with one M18 nut, the temperature range begins with 0 °C (32 °F). |
| Height | 31 mm |
| Height 31 mm Width 21 mm Length 23 mm | Height | 31 mm | Width | 21 mm | Length | 23 mm |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Temperature influence | ≤ ± 0.75 % of the end value (with temperature compensation) from 10 minutes after switching on the sensor ; 0.17 %/K (without temperature compensation) |
| Другое | |
| 0 Level | 0 ... 1 V |
| 1 Level | 2.5 V ... U B |
| Adjustment range | 70 ... 800 mm |
| Beam width | wide |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Color | black |
| Common mode operation | ≤ 82 Hz |
| Common mode operation ≤ 82 Hz Multiplex operation ≤ 82 Hz / n , n = number of sensors , n ≤ 10 | Common mode operation | ≤ 82 Hz | Multiplex operation | ≤ 82 Hz / n , n = number of sensors , n ≤ 10 |
| Compatible master port type | A |
| Connection type | fixed cable with plug |
| Core cross section | 0.19 mm 2 |
| Dead band | 0 ... 60 mm |
| Degree of protection | IP67 |
| Device ID | 0x300306 (3146502) |
| Device profile | Smart Sensor |
| Housing | Polycarbonate |
| Housing Polycarbonate Transducer epoxy resin/hollow glass sphere mixture; polyurethane foam | Housing | Polycarbonate | Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam |
| Input/output type | 1 synchronization connection, bidirectional |
| Installation position | any position |
| Interface type | IO-Link (via C/Q = Pin 4) |
| IO-Link revision | 1.1 |
| LED green | solid: power on flashing: standby mode or IO-Link communication |
| LED red | solid: error flashing: switch point programming, object not detected |
| LED yellow | solid: object in evaluation range flashing: switch point programming, object detected |
| Length | L | 200 mm |
| Mass | 20.5 g |
| Material | PUR |
| Material PUR Color black Number of cores 4 Core cross section 0.19 mm 2 Length L 200 mm | Material | PUR | Color | black | Number of cores | 4 | Core cross section | 0.19 mm 2 | Length | L | 200 mm |
| Min. cycle time | 2.3 ms |
| Multiplex operation | ≤ 82 Hz / n , n = number of sensors , n ≤ 10 |
| Non-volatile memory | EEPROM |
| Number of cores | 4 |
| Number of pins | 4 |
| Output | Switching point 800 mm Output mode: Switching point Output logic: normally open |
| Output type | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected |
| Process data width | 16 bit |
| Pulse length | ≥ 1 ms with external control, low active |
| Range hysteresis | H | 1 % of the adjusted operating range (default settings), programmable , min. 1 mm |
| Scope of delivery | 1 Nut plastic |
| Sensing range | 60 ... 800 mm |
| Sensor cycle time | ≥ 13 ms (factory setting) ; programmable to 60 s |
| SIO mode support | yes |
| Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 IEC 61131-9:2013 |
| Standards EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 IEC 61131-9:2013 | Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 IEC 61131-9:2013 |
| Standard target plate | 100 mm x 100 mm |
| Threading | M12 |
| Threading M12 Number of pins 4 | Threading | M12 | Number of pins | 4 |
| Tightening torque, fastening screws | max. 0.2 Nm |
| Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam |
| Transfer rate | COM2 (38.4 kBit/s) |
| UL approval | cULus Listed, Class 2 Power Source |
| Width | 21 mm |
| Write cycles | 300000 |
Изображения
Документы
К этому компоненту пока не привязаны документы.